Regeneration Process - Prime BASIC RPT-T300 User Manual

Regeneration Process

Summary of Identification & Regenerating Process for 12V / 95Ah SLI MF Battery (Car)
Battery Checking
Condition Test
(Identification)
OK Test Finish
Reg Regenerating
Checking Report
Battery Checker
- SoC - Voltage
- CCA - Internal resistance
Physical inspection for
any damaged in
surface of battery.
ndition Test
dentification)
CASE 1
CASE 2 CASE 2
Less 70% of designed RC
Regenerating Again
Judging as sucess of regenerating
in case over 70% of designed RC
on battery specification.
Checking Report
Battery Cell Cut Batt
Batte Battery Cell Short
Battery Cell Corrosion Battery Ce
KEEP to Regenerate
PRIME charging voltage is going to 13V within about 40 minutes.
G GIVE UP (Battery is Cell Cut)
P PRIME charging voltage is rapidly going to 15V within 1 minute.
GIVE UP
CASE CASE 3
PRIME charging voltage is not going to 13V from 12V
within around 1 hour.
GIVE UP (Battery is Cell Short)
CASE 4
PRIME charging voltage is not going to 12V within
about 10 minutes.
Discharging for
RC check
Over 70% of
designed RC
Load Test by
Battery Checker
- SoC (State of Charge)
- Voltage
- CCA (Cold Cranking Ampere)
- Internal resistance
Identified as
BAD batteries
to be recycled
to the lead
(Disposal)
KEEP to Regenerate
Final Regeneration