Power Supply Mode - Prime BASIC RPT-T300 User Manual

Power Supply Mode

Caution : This Mode is a manual control mode for expert user who has a wealth of information about battery regeneration, and
he can regenerate and charge battery as he wanted. The accident damaged to human, battery or machine cannot be
protected from service or compensation if the none-expert user uses the machine without enough knowledge about manual.
This mode can control set-up voltage, hourly input current, and progress time manually for special battery which is
not included in battery type, sleeping battery which has lowered voltage due to non-use for a long time and some
battery only need a little regenerate/charge. It is a special power supply function for lead-acid batteries.
The way of input Set Values
SELECT Button
Function(Mode) set-up
1.
2. Target voltage set-up
3. Hourly supply current set-up
Time Set-up
Set-up total working time by using
4.
5. Internal Resistance / CCA value measure
6. Start and Pause
You can start the work by pushing
completed and check the Internal Resistance and CCA measure of before regeneration. You can pause the work
by using
Progress condition display
7.
LCD Indicator
Set up part. of the LCD indicator changed or designate to POWER SUPPLY by pushing
in the front part of the machine.
Make the arrow ( ) located in the Battery Voltage / CV of part.
You can go on to the next work by pushing
charge voltage to 15.6V by using
the maximum target charge voltage 2.6V per 1 cell)
You can go on to the next work by pushing
regenerated battery capacity to the 1/10 value by using
is located to the Capacity (Ah) / Current (A) of part.
UP and
Refer to "4. Internal Resistance / CCA value measure" in "Regeneration Mode" of
previous page.
START / STOP button in front part of the machine after input 1~4 topic is
START / STOP button during the work.
The supplied voltage is displayed in
current amount in Capacity(Ah) / Current(A) and the elapsed time of previous set-up time is
displayed in Run Time(H:M) in real time.
by pushing
ENTER button again after set-up the maximum battery target
UP button and DOWN button.(12V battery is set-up to 6 cells and
SET
ENTER button again after set-up the exterior showed
UP and
.
(Warning : That is not the capacity input.)
SET
DOWN button when the arrow is located in Run Time (H:M) of part.
Battery Voltage / CV under the WORK part, the hourly
Control Button
SELECT button
SET
ENTER button.
DOWN button when the arrow
SET
.