Part Name - Prime BASIC RPT-T300 User Manual

Part Name

LCD Display Indication Information
POWER LED
When you switch on the rear switch
SELECT Button It is a function selecting button if you push this button
If you push this button again you can change the function.
Function Indicating LED
ENTER Button
You can use this button to go on next work after inputting regeneration(or charge) battery type into the machine.
UP Button
You can use this button to increase set value in voltage, current or time set-up of the battery. It increases 1 unit in
REGENERATION MODE or CHARGE MODE and it increases 0.1 unit in POWER SUPPLY MODE or DISCHARGE MODE.
If you push this button continuously the set value increased automatically.
DOWN Button
You can use this button to decrease set value in voltage, current or time set-up of the battery. It decreases 1 unit in
REGENERATION MODE or CHARGE MODE and it decreases 0.1 unit in POWER SUPPLY MODE or DISCHARGE MODE.
If you push this button continuously the set value decreased automatically.
START / STOP Button
When you push START / STOP button the machine starts its work after inputting set value of battery voltage,
current and time is finished. If you push START / STOP button in working the machine work is stopped.
Displayed Contents of LCD Indicator
When you turn on the switch, each LED flicking one time
and then above LCD indicator is changed into Setting Mode
on the screen same as the right one.
Battery Voltage / CV
When you input standard(official) battery voltage in SET part, the real time voltage of connected battery is
displayed in WORK part. You can set-up a Cut-off Voltage (CV) at DISCHARGRE Mode.
Capacity / Current
When you input battery capacity in SET part, the supplied current amounts in real time are displayed in WORK part.
Run Time (H:M)
The progress time of by a selected mode is automatically displayed in SET part, and elapsed working time is displayed
in WORK part.
SET
Vertical line items under the SET, the battery set values(voltage, capacity, current and time) are displayed.
WORK
If you push START button vertical line items under WORK are displayed in real time after inputting set values of vertical line items
under the SET.
IR, CCA
If you push the ENTER button more than 2 seconds (Or, if you push the START button), the internal resistance and CCA values
of connected battery are automatically displayed in Before part. If regeneration, charge and discharge work is finished,
the internal resistance and CCA value are displayed in After part automatically.
You can input battery specification and see progress work condition in real time.
LCD display is turned on and the green light is turned on in
If you push item button, each function's LED are turned on and then you can check which function
is selected.
item LED is turned on and you can select the function.
POWER LED.