Table of Contents
Advertisement
Charge Mode
The way of set value input in Charge Mode
SELECT Button
Ex) 12V / 80Ah Battery Charge Work
Function(Mode) set-up
1.
2. Standard(official) battery voltage set-up
3. Input battery capacity
Internal resistance / CCA values measure
4.
DC 12V Battery Only
(Measure range : DC 11.0V ~ 14.0V)
IR Value
CCA Value
5. Start of pause of charge
Progress condition display
6.
LCD Indicator
Set up part.
of the LCD indicator changed or designate to CHARGE by pushing
button in the front part of the machine.
Make the arrow ( ) located in the Battery Voltage / CV of part.
ENTER. Designate the charged standard(official) battery voltage to the 12.0
by using
ENTER button again you can go on to the next work. (In this mode, you can
designate Battery Voltage of part.
Designate the showed exterior battery capacity to 80.0 by using
the arrow( ) located in the Capacity (Ah) / Current (A) of part.
You can measure Internal Resistance(IR) and CCA value during the battery is connected
regardless of the arrow( ) location. Before charge work those values are displayed
right part of LCD indicator after pushing
The displayed value in upper line is IR one and the lower line is CCA one.
This function cannot be worked during charge work after finishing charge work
the IR and CCA values in that moment displayed automatically.
You can start charge work by pushing
in part.
and check IR and CCA values of before charge.
You can pause charge work by using
After started charge supplied voltage is displayed in
in real time and the hourly supplied current is displayed in
The SET part of
Run time(H:M) is automatically set-up time and the elapsed set-up work time is
displayed under the WORK part.
UP button and
DOWN button. After Set-up is completed by pushing
to 6V, 8V or 12V)
SET
UP button and
.
ENTER button more than 2 seconds.
2 seconds
push
START / STOP button after input Capacity (Ah) / Current (A)
START / STOP button during the work.
Battery Voltage / CV under the WORK part
Capacity (Ah) / Current (A).
Control Button
SELECT
SET
by pushing
DOWN button when
SET
Advertisement
Table of Contents
