Table of Contents
Advertisement
Discharge Mode
The way of input Discharge Mode set values
SELECT Button
Ex) 12V / 100Ah Battery Discharge Work
Function(Mode) set-up
1.
2. Cut-off discharge voltage set-up
3. Set-up discharge current
4. Internal Resistance / CCA value measure
5. Start and Pause
You can start the discharge work by pushing
completed and check the Internal Resistance and CCA measure of before discharge. You can pause the discharge
work by using
Progress condition display
6.
RC(Reserve Capacity) value display
7.
LCD Indicator
Set up part.
of the LCD indicator changed or designate to DISCHARGE by pushing
button in the front part of the machine.
Make the arrow ( ) located in the Battery Voltage / CV of part.
Designate the discharge cut off voltage (CV) for 12V battery to 10.5 (normal 12V battery is
set-up 6 cells and normally designate the final discharge voltage to 1.75V per 1 cell) by using
UP button and
button again after set-up (1.75V X 6 cells = 10.5V).
You can go on to the next work by pushing
25A (International standard discharge current for car start battery) by using
button when the arrow ( ) is located in the Capacity (Ah) / Current (A) of part.
(Warning : Basically the discharge current for all car start batteries are '25A' according to the international
standard. But in case of industrial batteries, the discharges current are differently adjusted according to the
battery capacity, specification and time of the discharged battery.)
Refer to "4. Internal Resistance / CCA value measure" in "Regeneration Mode" of
previous page.
START / STOP button during the discharge work.
After started discharge work the current battery voltage is displayed in
the WORK the present discharging current amount in real time is displayed in
/ Current (A).
The elapsed discharge time is displayed in
discharge. The elapsed discharge time means RC(Reserve Capacity) value that is the most
important standard (Capacity Checking) of the battery.
DOWN button. You can go on to the next work by pushing
SET
ENTER button after designate the discharge current to
START / STOP button in the controller after input 1~3 values are
Run Time (H:M) in WORK part, after started
SET
Control Button
SELECT
SET
by pushing
ENTER button.
ENTER
UP button and
DOWN
SET
Battery Voltage / CV under
Capacity(Ah)
WORK
RC Value
Advertisement
Table of Contents
