Table of Contents
Advertisement
Battery Condition Test
Input way of Condition Test
SELECT Button
Ex) 12V / 100Ah Battery Regeneration Work
Function(Mode) set-up
1.
2. Nominal battery voltage set-up
3. Input battery capacity
Internal resistance / CCA values measure
4.
5. Start of pause of regeneration
Progress condition display
6.
Message Type Contents Explanation
7.
This is a Damage Identification Message that there is cell short more than 1cell in battery.
This is a Damage Identification Message that there is cell cut more than 1cell in battery.
This message appears when the battery voltage is less than DC 8V. Please retest after charge.
*
Prior to the
'CONDITION
charger for this recharge. (If a low voltage battery is not charged well, use a 'Power Supply' mode of PRIME)
- Most batteries lower than 11V will be cell corrosion states. – Limited capacity
set value
(Identification)
LCD Indicator
Set up part.
of the LCD indicator changed or designate to CONDITION TEST by pushing
button in the front part of the machine.
This mode is a 12V battery only. Thus it is fixed to 12V.
Designate the showed exterior battery capacity to 100.0 by using
the arrow( ) located in the Capacity (Ah) / Current (A) of part.
Refer to "4. Internal Resistance / CCA value measure" in "Regeneration Mode" of
previous page.
You can start condition test work by pushing
Current (A) in part.
and check IR and CCA values of before condition test.
You can pause condition test work by using
After started condition test supplied voltage is displayed in
WORK part in real time and the hourly supplied current is displayed in
Run time(H:M) is elapsed work time is displayed under the WORK part.
This is a message that the battery is possibly identified as to be regenerated or charged battery by finishing
Identification ordinarily.
This is a Damage Identification Message there is cell corrosion more than 1cell in battery.
This message appears when the battery voltage is more than DC 16V. This mode 12V battery only.
This message is displayed when there is no battery voltage, the +, - terminals are connected to the
battery differently, and one or both clips are disconnected due to external shock in machine working.
TEST', all 12V batteries should be charged to
Control Button
SET
UP button and
DOWN button when
.
START / STOP button after input Capacity (Ah) /
START / STOP button during the work.
Battery Voltage / CV under the
Capacity (Ah) / Current (A).
(Shorted Circuit Battery)
(Bad Battery)
over 9V
at least. Please use a conventional
SELECT
SET
(Bad Battery)
(Check Battery)
Advertisement
Table of Contents
