Figure 16 - Set Button Example - GE CSE Uniserve CB Watch 3 Operating Manual

Also in this Operating Manual, we will often (as in the example above) mask part of the page
displayed with a blue screen in order to focus attention on the relevant part of the page.
When changing any setting in the HMI, please note that before the adjustment of a
parameter can take effect, it first needs to be validated and stored by pressing the "Set" or
"Change" button in the corresponding sub-section.
Note that, while most changes will take place as soon as you press "Set", sometimes the
system will ask you to reboot after a big change, or will do it itself.
In particular, it is essential to reboot the system after any major change like:
• Changing settings from spring to pump type
• Changing the IEC 61850 configuration (it will reboot twice)
MA-037 - CB Watch 3 Operating Manual
Figure 16 – Set button example
v7.0 - May 2020 Page 19 of 118