Advertisement
Instruction Leaflet IL29C150G
Effective December 2011
CONTACT WITH ENERGIZED EQUIPMENT CAN
RESULT IN DEATH, SEVERE PERSONAL INJURY, OR
SUBSTANTIAL PROPERTY DAMAGE. DO NOT
ATTEMPT TO INSTALL OR PERFORM MAINTE-
NANCE ON EQUIPMENT WHILE IT IS ENERGIZED.
ALWAYS VERIFY THAT NO VOLTAGE IS PRESENT
BEFORE PROCEEDING WITH THE TASK, AND
ALWAYS FOLLOW GENERALLY ACCEPTED SAFETY
PROCEDURES.
EATON IS NOT LIABLE FOR THE MISAPPLICATION
OR MISINSTALLATION OF ITS PRODUCTS.
The user is cautioned to observe all recommendations,
warnings, and cautions relating to the safety of personnel
and equipment as well as all general and local health and
safety laws, codes, and procedures.
The recommendations and information contained herein
are based on Eaton experience and judgement,but should
not be considered to be ail-inclusive or covering every ap-
plication or circumstance which may arise. If any questions
arise, contact Eaton for further information or instructions.
1. INTRODUCTION
General Information
The shunt trip (Fig.
trical tripping for the circuit breaker. It consists of an inter-
mittent rated solenoid with a tripping plunger and a cutoff
switch attached to a plug-in module. The plug-in module
is mounted in slots in the accessory mounting deck in the
right pole of the circuit breaker. When the solenoid is
energized, the plunger extends and presses against the
trip bar. As the circuit breaker trips, the molded trip bar
rotates and allows the cutoff switch to open, disconnect-
ing power to the solenoid and preventing coil burn out.
Table 1-1 lists application and electrical operating ratings
data for the shunt trip.
2
EATON CORPORATION www.eaton.com
WARNING
provides remote controlled elec-
Installation Instructions for Shunt Trip for
R-Frame Series C Circuit Breakers and
Fig. 1-1
Trip Installed in R-FrameCircuit
Shunt
The standard wiring configuration for the shunt trip is pig-
tail leads exiting the right side of the cover. An optional
terminal block (Cat No. TBRD) may be mounted to the
right side of the circuit breaker to terminate attachment
ieads. The 18- inch (457.2 mm) long pigtail leads are color
coded
for
identification; numbered identification labels are
provided for pigtail leads.
This instruction leaflet (IL) gives detailed procedures for
installing the shunt trip.
2. INSTALLATION
Note:The shunt t r i p can be field installed in RD
and RDC circuit breakers under UL File E64983.
The shunt trip can be fieid-installed in RW and RWC
circuit breakers.
The
shunt trip is listed for factory installation under
UL File E7819.
Before attempting t o install the shunt trip, check that
the catalog number is correct as ordered and that the
rating of the accessory satisfies job requirements.
The shunt trip, shown in kit form in Fig. 2-1, is installed in
the right pole
of
a 3- or 4-pole circuit breaker. To install
the shunt trip, perform the following procedures:
Molded Case Switches
Breaker.
Advertisement
