PROAIM P-TP-100-B Assembly Manual

100mm bowl head tripod stand with rubber tripod shoes

100mm Bowl Head Tripod Stand With Rubber

Tripod Shoes

(P-TP-100-B)

A s s e m b l y M a n u a l

What's In The Box

Please inspect the contents of your shipped package to ensure you have received everything that is listed

below.

3 x Proaim Rubber Tripod Shoes

Bag Packing

100mm bowl Tripod Stand

No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means,

electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permitted by the applicable copyright

statutes or in writing by the Publisher.

Table of Contents

Need help?

Do you have a question about the P-TP-100-B and is the answer not in the manual?

Page 1 A s s e m b l y M a n u a l What’s In The Box Please inspect the contents of your shipped package to ensure you have received everything that is listed below. 3 x Proaim Rubber Tripod Shoes Bag Packing 100mm bowl Tripod Stand All rights reserved.
Page 2 Tripod Stand Setup • Properly spread and open all the legs of the tripod stand. • Then, spread the Mid-Level Spreader of the tripod according to your requirements and secure properly with the help of the provided knobs. • Attach a rubber tripod shoe to the bottom legs of the stand.
Page 3 • Remove the knob of the 100mm Bowl Fluid Head (Not Included) and mount it on the Tri- pod Stand. • Then, properly tighten and secure the knob of the Fluid Head (Not Included) from the bottom. • Pull and release the Fluid Head knob and then remove the camera plate.
Page 4 YOUR PROAIM 100MM BOWL HEAD TRIPOD STAND WITH RUBBER TRIPOD SHOES ALL DRESSED UP AND READY TO GO! (SHOWN WITH OPTIONAL ACCESSORIES) Warranty: We offer one year warranty for our products from date of purchase. Within this period of time, we will repair it without charge for labor or parts.