Generator Storage - K&S BASIC KSB 30A Owner's Manual

Gasoline generator

Hide thumbs

Table Of Contents

Table of Contents

1. Open the air filter cover.

2. Remove the sponge filtering element.

3. Remove all dirt deposits inside the hollow case of the air filter.

4. Thoroughly wash the filtering element in warm water.

5. Dry the sponge filter.

6. Dry filtering element is to be moistened by machine oil and excess oil

The generator must be stored in a dry, well-ventilated area that is free from dust. Keep away from children and

animals.

IMPORTANT!

GENERATOR LONG-TERM STORAGE

If the generator will not be used for a long time, it is recommended to:

- Drain the fuel into the tank.

- Drain the motor oil.

- Pull the manual starter until a slight resistance is felt so that the inlet and drain valves get closed.

- Clean the generator from dirt and dust.

When starting the generator after long-term storage, proceed as above in the reverse order.

For easy generator transportation use packaging, which generator was sold in. Secure the box with the generator to

avoid tipping it on the side of the carriage. Before moving the generator drain the fuel and disconnect the terminals

of the battery (if this model has a battery).

To move the generator from one place to another lift it by holding the frame (if generator has construction with open

frame). If generator has an silent cover, use transportation handles. Be careful, do not expose your feet under the

generator.

To prevent damage to the environment separate generator and battery from ordinary waste and recycle them in the

safest way passing a special place for disposal.

The international manufacturer warranty is 1 year. The warranty period starts from the date of purchase. In cases when warranty

period is longer than 1 year according to local legislation please contact your local dealer. The Seller which sells the product is

responsible for granting the warranty. Please contact the Seller for warranty. Within the warranty period, if the product fails because

of defects in the production process, it will be exchanged on the same product or repaired.

All faults caused by the manufacturer during the warranty period will be eliminated free of charge. Warranty repair is carried out

only if you have a fully completed warranty card, the Buyer's signature of acceptance of the warranty terms, as well as a document

supporting the purchase (cash receipt, sales slip or invoice). In the absence thereof, as well as in the event of errors or corrections

not authenticated by the seller's seal or illegible inscriptions in the warranty card or tear-off coupon, no warranty repair is carried

out, no objections to quality are accepted and the warranty card is withdrawn by the service center as invalid. The device is accepted

for repair clean and full.

CLEANING THE FILTER:

is to be squeezed out.

Potential faults and troubleshooting methods, as well as average device capacities can

be found in thefull version of the manual.

Generator should always remain ready for operation. Therefore

in case of device malfunctions, they are to be repaired before dis-

mounting the generator for storage.

GENERATOR TRANSPORTATION

GENERATOR AND BATTERY UTILISATION