PIONEER DJ DDJ-FLX6-GT Instruction Manual page 69

Select [Activate the fader start when moving a channel fader or the
crossfader while pressing the SHIFT button.] to turn the setting on.
[CROSSFADER] > [Cut Lag] setting
Adjust the amount of Cut Lag at both edges of the crossfader.
You can make adjustments in increments of 0.1 mm within a range of
0.3 mm to 5.5 mm.
• The default Cut Lag amount is 1.0 mm.
• The setting amount for the Cut Lag is a guide, and may not be exact.
[Booth Output] setting
Change whether or not the microphone sound comes out of the booth
channel.
If you don't select [Don't output microphone sound to the Booth
output.], the microphone sound comes out of the booth channel. If you
select the setting, microphone sound doesn't come out of the booth
channel.
[Controller] > [Effect] tab:
• [Enable MERGE FX]:
Merge FX is enabled and the [MFX] panel is displayed on the FX
panel.
When the unit is connected, this setting is enabled.
• [Stop playing the operating deck after MERGE FX finishes.]:
When you select this, playback automatically stops on the deck after
Merge FX is canceled.
69
En
rekordbox