PIONEER DJ DDJ-FLX6-GT Instruction Manual page 106

Back Spin Length
When using a jog wheel to perform a Back Spin, you can make the
Back Spin longer or shorter than the amount you rotate the jog wheel
by.
You can set the Back Spin Length to short, normal, or long.
Press one of the Performance Pads 1 through 3 on the right deck.
• Pad 1 is lit: Back Spin Length short
• Pad 2 is lit: Back Spin Length normal (Default)
• Pad 3 is lit: Back Spin Length long
Fader Start
Press the [HOT CUE] mode button on the left deck.
• [HOT CUE] mode button is lit: Fader Start is turned on. (Default)
• [HOT CUE] mode button is not lit: Fader Start is turned off.
Crossfader Cut Lag
You can adjust the cut lag (the range where no sound is heard from the
relevant deck) at both edges of the crossfader.
You can make adjustments in increments of 0.1 mm within a range of
0.3 mm to 5.5 mm. (Setting value: 1 through 53)
• The setting amount for the Cut Lag is a guide, and may not be exact.
• The default Cut Lag amount is 1.0 mm. (Setting value: 8)
Turn the rotary selector.
The number of lights that are lit up on the channel level indicators
indicates the setting value (1 through 53).
• The number of lights that are lit up on the channel level indicators on
channel 1: tens place.
• The sum of the number of lights that are lit up on the channel level
indicators on channel 2 and 4: ones place.
Changing the settings
106
En