I/O Interface Specification - Panasonic LP-RF Series Setup & Maintenance Manual

4-1 I/O Interface Specification

The I/O terminal block and the I/O connector are available as the external control I/O interface of this product.
• I/O terminal block: Loaded with the basic input/output to control the laser marker.
• I/O connector: Loaded with the input/output for data configuration such as selecting a file number and the input/output
for the specific functions.
• Before using I/O, configure the system settings. Refer to "3-4-3 General settings before external control" (P.77).
Hook
The I/O terminal block can be
removed by holding down the
hooks.
„ Connector specifications and models
Connector position
I/O terminal On the laser
block marker side
User side
I/O Connector On the laser
marker side
User side
„ Wiring of input/output lines
Install one of the ferrite cores included in this product to the wirings from the I/O
terminal and another one to the lines from the I/O connector.
If the diameter of the ferrite core is too large, turn the I/O lines around the ferrite
core as shown in the figure.
82
X1 Y1
X2 Y2
X3 Y3
X4 Y4
X5 Y5
X6 Y6
X7 Y7
X8 Y8
X9 Y9
X10 Y10
X11 Y11
X12 Y12
X13 Y13
X14 Y14
X15 Y15
X16 Y16
X17 Y17
X18 Y18
X19 Y19
X20 Y20
I/O terminal block
Connector specifications
Dedicated connector
MIL connector
40-pin/male
MIL connector
40-pin/female
ME-LPRF-SM-11
Rear of controller
Model
15EDGRHCM-THR-3.5-40P-1
Accessories: 15EDGKNHG-
3.5-40P-14-00A
XG4A-4034
Accessories: XG4M-4030-T
Ferrite cores
1 2
39 40
I/O connector
(Laser marker)
Manufacturer name
Degson Electronics
Co., Ltd
OMRON Corporation
Rear of controller