Count-Up/Count-Down Value Correction - Panasonic LP-RF Series Setup & Maintenance Manual

4-6-14 Count-up/count-down value correction

SELECT 0 - 2 IN (No.19-21)
D0 - D7 IN (No.3-10)
D8 - D15 IN (No.10-18)
SET IN (No.2)
SET OK OUT (No.28)
TRIGGER IN (X5)
READY OUT (Y5)
PROCESSING OUT (Y10)
Item Time
T1 0.5ms or more
T2 0ms or more
T3 2 to 510ms
T4 0ms or more
T5 2ms or more
*1 : Select the number input target with SELECT 0 IN to SELECT 2 IN as follows.
Number input target
Count-up value correction
Count-down value correction
*2 : Select a value from D0 to D7 for the counter number to correct the count-up/count-down value. The counter No. 0 to 3
is assigned at D0 to D3 and the common counter No. 16 to 19 is assigned at D4 to D7 respectively.
*3 : Specify a value in D8 to D15 for the step times of count-up or count-down in the binary system.
• To specify the next counter value during the trigger processing, input SET IN (No.2) after PROCESSING OUT (Y10)
turns ON.
• If the count-up/count-down correction is input during on-the-fly marking operation, READY OUT (Y5) turns off
momentary and there is a case that the next marking could not be executed due to Warning E751.
120
ON
*1
OFF
ON
*2
OFF
ON
*3
OFF
ON
T1
OFF
T2
ON
T3
OFF
ON
OFF
ON
OFF
ON
OFF
Remarks
After a lapse of 0.5ms or more from specifying SELECT 0 IN to SELECT 2 IN and D0 IN to
D15 IN, turn on SET IN (No.2).
Keep the input until SET OK OUT (No.28) turns on.
One-shot output. Set the output time on the system settings screen.
There is a small margin of error for the setting value.
Turn on TRIGGER IN (X5) after SET OK OUT (No.28) turns on.
Keep the ON status for 2ms or more.
SELECT 0 IN (No. 19)
OFF
ON
ME-LPRF-SM-11
T4
T5
SELECT 1 IN (No. 20)
ON
ON
SELECT 2 IN (No. 21)
OFF
OFF