Test Marking And Run Mode - Panasonic LP-RF Series Setup & Maintenance Manual

3-3-6 Test marking and RUN mode

When you execute marking using the PC configuration software control, the laser irradiates in the following methods:
„ Test marking procedure
Test marking is a marking method of radiating laser by the operations on the Laser Marker NAVI smart.
1.
Establish an online connection between your PC and the laser marking system and go to the "Marking settings"
screen.
2.
Select "Laser pumping" in the ribbon to turn on the laser pumping.
3.
Click "Test marking" in the ribbon.
The "Test marking/guide laser" dialog appears.
4.
Specify the laser settings such as "Laser power" and
"Scan speed [mm/s]", then select "Start marking".
5.
A confirmation dialog of the laser radiation appears. Click "Yes" to start
radiating the laser.
WARNING
• Take appropriate protective measures during laser radiation such as wearing
laser protective goggles or using a protective enclosure.
ME-LPRF-SM-11
"Laser pumping" tool
ON status OFF status
"Test marking" tool
73