Windows Vista - IBM T-120 User Manual

Driver Installation for Windows VISTA
This section must be
completed before continuing
with the Windows VISTA
Setup
on page 13
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality .IBM recommends using
1600 x1200 at a fresh rate of
60Hz
To install the device driver in use the Plug and Play feature in Microsoft
Windows Vista files should be loaded from the IBM Monitor CD.
®
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
Auto
3. Turn on the monitor and then the system unit. Allow the system to boot
into Windows Vista
4. Open the
and then double-clicking the
PANEL
5. Click the
6. Click the
7. Click the Monitor tab.
8.
Click the Properties button, Click the Continue button
9. Click the
10. Open the "Update Driver Software-Generic PnP Monitor" window by
clicking on
driver software"
11. Select the "Let me pick from a list of device on my computer"
12. Insert the Setup CD into the CD drive: and click the
13. Ensure that the CD drive letter is selected.
14. Click OK.
15. Choose X:\driver\windows vista driver\IBM4945 and click OK. and click
OK. The files will be copied from the CD to your hard disk drive.
16. Close all open windows and remove the CD.
17. Restart the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
DISPLAY PROPERTIES
button.
Display Settting
Advanced Setting button
tab.
DRIVER
and then click the
Update Driver
button.
window by clicking
START
icon.
Personalization
.
"Browse my computer for
HAVE DISK
®
,
CONTROL
button.
11