Windows Vista - IBM T117 User Manual

Driver Installation for Windows VISTA
This section must be completed
before continuing with the Windows
Auto Setup
VISTA on page 13
On LCD monitors, unlike
CRTs, a faster refresh rate
does not improve display
quality .IBM recommends using
either 1280 x1024 at a fresh rate of
60Hz or 640 x480 at a refresh rate of
60H
To install the device driver in use the Plug and Play feature in Microsoft
Windows Vista files should be loaded from the IBM Monitor CD.
®
1. Turn off the computer and all attached devices.
2. Ensure that the monitor is connected correctly.
3. Turn on the monitor and then the system unit. Allow the system to boot
into Windows Vista
4. Open the
DISPLAY PROPERTIES
and then double-clicking the
PANEL
5. Click the
Display Settting
6. Click the
Advanced Setting button
7. Click the Monitor tab.
8. Click the
Properties
9. Click the tab.
DRIVER
10. Open the "Update Driver Software-Generic PnP Monitor" window by
clicking on
Update Driver
button.
driver software"
11. Select the "Let me pick from a list of device on my computer"
12. Insert the Setup CD into the CD drive: and click the
13. Ensure that the CD drive letter is selected.
14. Click OK.
15. Choose X:\driver\windows vista driver\IBM4943/4944 and click OK.
The files will be copied from the CD to your hard disk drive.
(where X is the drive letter designator for the CD-ROM drive).
16. Close all open windows and remove the CD.
17. Restart the system.
The system will automatically select the maximum refresh rate and
corresponding Color Matching Profiles.
window by clicking
Personalization
button.
.
button, Click the Continue button .
and then click the
,
START CONTROL
icon.
"Browse my computer for
button.
HAVE DISK
11
®