Operation Guidance; Examination Before Start-Up; Start-Up; Set The Temperature And Time Values - Thermo Scientific 88870001 User Manual

Dry bath with advanced microprocessor control

Hide thumbs Also See for 88870001:

Operating manual (21 pages)

Table Of Contents

Table of Contents

Examination Before

Set the Temperature

and Time Values

Thermo Scientific

Section 6

The chapter introduces the display window and the operation of buttons

of the dry bath with constant temperature.

Confirm the following before inserting the plug into the power socket.

Start-Up

1. Ensure the power source is in accordance with the voltage requirement

of the instrument (refer to Features section for voltage requirements).

2. Make sure the plug has been fully plugged into the power socket.

3. Ensure the power line has been reliably grounded.

Caution If the display of the instrument is abnormal after startup, turn off

the power source immediately and contact the supplier.

Start-Up

Press the power switch and the instrument will power on. All indicator

lights and display serial ports will be turned on. About 3~5 seconds later,

temperature display window will show the real-time temperature. All

indicator lights will be turned off.

When the instrument is not running, press "SET/CAL.", the instrument

will enter setting status. At that time, temperature display window shows

the previous temperature value with the first figure on the left flashing.

Press "SHIFT", the flashing place can be moved, press "▲"or "▼"to

increase or decrease the flashing figure.

When the temperature is set, press "SET/CAL." to enter into the time

setting mode and the time display window shows the previous time value

with the first figure on the left flashing. Press "SHIFT", the flashing place

can be moved, press "▲"or "▼"to increase or decrease the flashing figure.

Wait for 5 seconds after setting, and do not operate the instrument. After

5 seconds, the instrument will automatically exit, setting the status. The

temperature window will show real-time temperature.

Instruction: There is limitation for temperature and time setting. The

setting temperature range is: 15~135°C；the time range is: 0~99h59min

and continuous mode "--:--".