Table of Contents
Advertisement
6802988C54-D
Chapter 2: VML750 Installation
Installing the SIM
If your VML750 is intended for use on your private Motorola LTE network, you are provided with a
Motorola LTE SIM card (to be inserted into SIM1 slot). If your VSM is intended to home on a public
carrier LTE network, you must obtain a SIM card from that public carrier and insert it into SIM2 slot.
The VML750 can be used a WiFi modem without the need for a SIM card. When using the VML750 as
a WiFi modem, the VML75 must be configured prior to use. For VML750 configuration, refer to
VML750 Configuration Guide (6802988C55) at https://businessonline.motorolasolutions.com.
Procedure:
1 Locate the SIM card door on the front right side of the VML750. Unscrew the door and put to the
side.
NOTICE: If a SIM card is in the slot, your LTE modem has been staged for you
(seeVML750 Configuration Guide PN 6802988C55 if required); skip to
2 Locate the SIM card Motorola or your public carrier provided. Hold the card so that the metal
contacts are facing down.
3 Insert the card into the SIM slot until you feel it 'click' into place.
NOTICE: SIM 1 slot is for private network. SIM 2 slot is for public carrier network.
4 Close the door and screw it into place. Tightened the screw so that the door does not move.
Replacing the CRYPTR Card
Perform this procedure to replace the CRYPTR card in the VML750.
CAUTION: Disconnect your VML750 from the power source before performing this procedure.
Procedure:
1 Perform the following actions to remove the CRYPTR card.
a On the VSM bottom cover, open the two Torx 8 captive screws fastening the CRYPTR card
door.
b Use one of the captive screws to pull the door from the cover.
Figure 12 opening the CRYPTR Card Door
22
step
4.
Send Feedback
Advertisement
Table of Contents
