Installing the LAN/Ethernet Cable
Perform this procedure to install the LAN/Ethernet cable.
Procedure:
1 Connect the LAN/Ethernet cable from the LAN connector on the VML750 LTE Vehicular
Subscriber Modem (VSM) Connector panel to your vehicle Mobile Data Terminal.
CAUTION: Do not use pliers or any other metallic tool for tightening. Hand- tighten
only. Fully tighten the LAN/Ethernet cable connector and verify it is fastened.
2 Follow the LAN/Ethernet cable 8 +/–2 inches (20 +/–5 cm) from where it attaches to the VML750
and secure it to the vehicle body.
Installing the Micro USB Cable
Perform this procedure if you are not installing the LAN/Ethernet cable.
Procedure:
1 Connect the Micro USB cable from the Micro USB connector on the VML750 LTE Vehicular
Subscriber Modem (VSM) Connector panel to your vehicle Mobile Data Terminal USB
connector.
CAUTION: Do not use pliers or any other metallic tool for tightening. Hands tighten
only. Fully tighten the Micro USB cable connector and verify it is fastened.
2 Follow the Micro USB cable 8 +/–2 inches (20 +/–5 cm) from where it attaches to the VML750
and secure it to the vehicle body.
Send Feedback
6802988C54-D
Chapter 2: VML750 Installation
21