Installing The Modem; Installing The Battery - Motorola SBV6220 DOCSIS Installation Manual

3
To install and configure the SBV6220 Digital Voice Modem for a single PC with Microsoft
Windows, do the following:
•
Install the battery.
•
Connect the modem to your computer and telephone.
•
Set up Internet access and verify the IP address for your computer.
CAUTION: This product is for indoor use only. Do not route the Ethernet and telephone cables outside of the
building. Exposure of the cables to lightning could create a safety hazard and damage the product.

Installing the Battery

First, install the battery in the modem before installing any other components.
Before starting the battery installation, refer to
Lithium-Ion Battery
Note: The battery may take up to 12 hours for a full charge.
1. To remove the battery cover, place the modem on its side (LEDs facing up) and
press down on the two locking tabs.
2. Slide the battery into the battery compartment until it is fully seated.
3. Replace the battery cover.
Installing the Modem • Installing the Battery
SBV6220 DOCSIS 3.0 Digital Voice Modem • Installation Guide
548415-001-a

Installing the Modem

for information.
7
S afety Requirements for the SBV6220
2
B