Powering Up The Modem; Figure 13 Installing The Cryptr Card - Motorola VML750 Installation Manual

Vehicular subscriber modem (vsm)i

Hide thumbs Also See for VML750:

Table of Contents

6802988C54-D

Chapter 2: VML750 Installation

2 Using the above illustrations, perform the following actions to install the CRYPTR card.

a Insert the CRYPTR card into its location in the VSM.

b Lower the lock and push it forward to lock it.

c Install the card door on the VSM lower cover.

d Close two Torx 8 captive screws. Fasten with a torque of 12 inch-lb.

Powering Up the Modem

Perform this power-up procedure after installing the VML750 LTE Vehicular Subscriber Modem (VSM).

Procedure:

1 Verify that the vehicle ignition switch is in On position.

2 Press and hold the power button on the LED Indicator Panel for 2 to 3 seconds. Release the

button when the Power LED turns green (blinking or solid).

3 If your modem is connected to a computer using LAN/Ethernet/USB cable, the LAN LED turns

green. If no LAN/Ethernet/USB cable is connected, the LAN LED is off.

4 The GPS LED blinks orange while your modem is searching for GPS satellites. After satellites

are acquired, the GPS LED turns green.

NOTICE: The time for acquiring satellites during initial power up may take up to 5

minutes.

Send Feedback

Table of Contents