LAN/Ethernet Cable Installation
Procedure 2-5 How to Install Antenna Cables (Main and Diversity) (Continued)
2
LAN/Ethernet Cable Installation
Procedure 2-6 How to Install the LAN/Ethernet Cable
1
2
Micro USB Cable Installation
Procedure 2-7 How to Install the Micro USB Cable
1
2-18
For the Main antenna, connect the RF cable from the antenna to WWAN2 main.
Do not use pliers or any other metallic tool for tightening. Hand tighten
only! Fully tighten the antenna cable connector and verify it is well
fastened.
Connect the LAN/Ethernet cable from the LAN connector on the Connector panel
to your vehicle's Mobile Data Terminal.
Do not use pliers or any other metallic tool for tightening. Hand tighten
only! Fully tighten the LAN/Ethernet cable connector and verify it
is well fastened.
Follow the LAN/Ethernet cable 8 ±2" (20 ± 5 cm) away from where it attaches to
the VML750 and secure it to the vehicle body.
Perform the following procedure if you are not installing the LAN/Ethernet cable.
Connect the Micro USB cable from the Micro USB connector on the Connector
panel to your vehicle's Mobile Data Terminal USB connector.
Do not use pliers or any other metallic tool for tightening. Hand tighten
only! Fully tighten the Micro USB cable connector and verify it is
well fastened.
Chapter 2: VML750 Installation
6802988C54-B July 2014