Fcc Part 15 Information To User; General Information; Equipment Description; Installer Responsibilities - Briggs & Stratton 040661 Installation And Operation Manual

Owner Responsibilities

FCC Part 15 Information to User

Pursuant to part 15.21 of the FCC Rules, beware that
changes or modifications to the product not expressly
approved by Briggs & Stratton could void your authority
to operate the product.
This device complies with part 15 of the FCC Rules.
Operation of this unit is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
Turn this equipment on and off to determine if it causes
harmful interference to radio or television reception. If the
user discovers harmful interference, the user should try
to correct the interference by taking one or more of the
following steps:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment into an outlet on a circuit,
ensuring that the circuit is not the same one that the
receiver uses.
• Consult the dealer or an experienced radio/TV
technician for help.

GENERAL INFORMATION

For most applications, the Installation and Operation
Manual contains all the information required to correctly
install, operate, and maintain the generator. Briggs
& Stratton has made every effort to ensure that the
information in this manual is accurate and current.
However, Briggs & Stratton reserves the right to
change, alter, or otherwise improve the product and this
document at any time without prior notice.

Equipment Description

This product does NOT qualify for
either an emergency standby or legally required standby
system as defined by NFPA 70 (NEC).
• Emergency generator systems are intended to
automatically supply illumination and/or power to
designated areas and equipment during the failure
of the normal supply. Emergency systems can also
provide power for such functions as ventilation where
essential to maintain life, where current interruption of
the normal supply would produce serious life, safety,
or health hazards.
• Legally required standby generator systems are
intended to automatically supply power to selected
loads during the failure of the normal source (which
can create hazards, hamper rescue, or hinder fire-
fighting operations).

Installer Responsibilities

• Read and obey the safety instructions.
• Install only a listed transfer switch that is compatible
with the generator.
• Read and obey the instructions in this Installation and
Operation Manual.
• Installation must strictly comply with all applicable
codes, industry standards, laws, and regulations.
• Allow sufficient room on all sides of the generator for
maintenance and service.
• Discuss the generator placement with the owner.
• Give the Quick Operation Manual (part number:
80103363) to the owner after the installation has been
completed.
Owner Responsibilities
• Read and obey the instructions in this Installation and
Operation Manual.
• Follow a regular schedule for maintaining and using
the generator, as specified in this manual.
• Carbon monoxide detector(s) must be installed and
maintained indoors according to the manufacturer's
instructions and recommendations. Smoke alarms
cannot detect carbon monoxide gas.
• Smoke detector(s) must be installed and maintained
indoors according to the manufacturer's instructions
and recommendations. Carbon monoxide alarms
cannot detect smoke.
8
General Information
Part No. 80106286
Revision C