Please note additional instructions for use Fire safety Installation Cleaning and maintenance ADDITIONAL INSTRUCTIONS FOR USING YOUR TEMPUR ARC™ ADJUSTABLE AND STORAGE BED ADDITIONAL INSTRUCTIONS FOR USING YOUR TEMPUR ARC™ STORAGE BED ADDITIONAL INSTRUCTIONS FOR USING YOUR TEMPUR ARC™ ADJUSTABLE BED Troubleshooting...
Welcome to TEMPUR® Thank you and congratulations on choosing TEMPUR®. This guide includes everything you need to know about caring for and getting the best out of your TEMPUR ARC™ product. GENERAL SAFETY INSTRUCTIONS - APPLICABLE FOR ALL BED TYPES: TEMPUR ARC™ Static, TEMPUR ARC™ Adjustable, TEMPUR ARC™...
Symbols The following symbols are used on product, packaging or in this manual. Open the packaging carefully, so Do not cut deep into the as not to damage the product and packaging. Handle with care. its parts. Dispose of the packaging safely and as sustainably as possible in your local area.
That 'new product' smell Some people notice a slight odour to their new TEMPUR ARC™ product once unpacked. This is completely harmless and will disappear after a short period of use. Please note additional instructions for use Please read the following information clearly as this will provide guidance on how to use your product and what to expect in the first few months.
Fire safety TEMPUR ARC™ Bed Range products comply with applicable safety standards, which may vary depending on the product or the region. Further information is available upon request. Carelessness causes fire - we strongly recommend not to smoke in bed.
WARNING • Only use this TEMPUR ARC™ Adjustable and Storage bed for its intended use, as described in this manual. • This appliance can only be used by the below users when supervised or instructed on safety use and full understanding of resulting risks.
ADDITIONAL INSTRUCTIONS FOR USING YOUR TEMPUR ARC™ STORAGE BED WARNING • Keep your head away from the frame. Be very careful not to hit your head while opening the frame. Be aware that during opening, on the middle way up the lifting mechanism applies powerful force to lift the system up to the end.
Troubleshooting This chapter describes troubleshooting methods for fixing problems during installation and daily use. PLEASE CHECK THE ADJUSTABLE FRAMES ASSEMBLY GUIDES FOR PAIRING AND UNPAIRING OF REMOTES AND MOTORS What do you do in case of error: If you experience an error that is not listed in the table below, please contact your sales agent/ supplier.
Additional info about cleaning and maintenance of electrical components NOTICE • Always disconnect the power supply before you start to clean the drive system! • Never clean the motor unit in an automated washing system or with a high- pressure cleaner. •...
Dismantling the motor unit CAUTION • Electrical components should be connected or disconnected only when the power supply cord is unplugged. • Danger of pinching/crushing injuries! Be sure to carry out work on the drive in a position so that no loads bear on it. This is to ensure you avoid any risks of crushing or injury.
Page 12
DOC.N.:BF600005 DECLARATION OF CONFORMITY The manufacturer, Osaühing Bed Factory Sweden, a subsidiary of Tempur Sealy International, Inc. registered in Riia 66, EE-71009 Viljandi, Estonia, declare that the following product, TEMPUR ARC™ Adjustable Bed bases as delivered, is in conformity with the requirements of the following EU directives and...
For how long? The TEMPUR® Warranty lasts for the period displayed on or inside the packaging of the relevant product or as stated below, starting from the date of purchase (except where the product is an ex-display or demonstration model in which case the warranty starts from the date of manufacture).
Page 14
The Manufacturer will refund the reasonable delivery cost of returning a defective product for repair or replacement so long as the claim is valid under the terms of this TEMPUR® Warranty and the product is returned from an address within the same country as the authorised retailer the product was purchased from.
Page 15
To claim under the TEMPUR ARC™ Warranty you must: • contact the authorised retailer you originally purchased the product from (the “Seller”). If the Seller is either no longer in business or is no longer a TEMPUR ARC™ bed authorised retailer, please contact the Manufacturer.
Page 16
The liability of the Manufacturer is limited to the cost of repair and/or replacement of the product under the TEMPUR ARC™ bed Warranty. Accordingly, the Manufacturer will not be liable for all other liability for loss or damage howsoever caused arising out of the purchase, possession, sale, or use of the product.
Need help?
Do you have a question about the ARC Static and is the answer not in the manual?
Questions and answers