TEMPUR Ardennes User Manual

ADJUSTABLE BED WITH MASSAGE UNIT USER MANUAL
SAFETY INSTRUCTIONS
1. People with heart pacemakers must not use the massage unit, as the unit may possibly affect the
pacemaker.
2. Never open the housing of the controls and motors - doing so will void your warranty.
3. Check that the cables and housings are not damaged, if this is the case do not use the adjustable unit and
contact your dealer.
4. Any repairs must be approved prior to works being undertaken otherwise you could void your warranty.
5. When the mechanism are in use please do not sit directly on or apply pressure to any raised section of
the bed base. Your adjustable bed base must always be returned to the horizontal position before getting
into or out of the bed.
6. Do not allow liquids to get into controls or motors.
7. Do not look directly into the torch and the LED light.
8. The massage unit is designed for use in enclosed dry living areas.
9. Please ensure that children do not play with the remote control - keep the remote control out of reach of
children.
REMOVING PACKAGING / FITTING THE FINISHINGS
1. Unwrap from packaging / bag and remove fabric straps
used to secure drawers.
2. Remove the orange straps used to secure the slatted frame
during transit.
3. Insert each of the supplied castors into the holes of the
underside of your adjustable base(s). Tap in gently with a
rubber mallet if required.
4. Attach headboard (if ordered) using the supplied
headboard bolts. Find the feral by running your hand
over the head end, which is under the material. Using the
headboard bolt gently pierce the fabric and make a few
turns into the feral then remove. Place the headboard in
place and then screw in the headboard bolts tightly enough
Pack contents (Single Base):
· 6 x castors
· 4 x headboard bolts (if ordered)
· 1 x mattress support bar
Metal chrome castor Headboard bolt Mattress support bar
to hold the headboard securely in place.
5. Attach the mattress support bar to the foot-end of the bed by
sliding onto the final slat nearest to the foot-end (see image
above).
6. If you have purchased a double, king or super king, affix
the linking bars to each of the bed bases using the supplied
butterfly bolts (2 x bolts per linking bar) to ensure that your
bases do not separate. Please note that you may need to
pierce the fabric of the bed base once you have determined
the fixing points for the butterfly bolts.
Pack contents (Two Bases):
· 12 x castors
· 4 x headboard bolts (if ordered)
· 2 x Linking Bar
· 4 x Butterfly bolts
· 1 x mattress support bar
Butterfl y Bolts Linking Bar