AWS SEAL-N-WEIGH User Manual page 7

III. OPERATING INSTRUCTIONS
1. Take out the power cord from the packaging. Plug it into
the AC power port. Then plug it into an electrical outlet.
The power indicator light on control panel will become
illuminated.
2. Gently turn the levers on both sides of the appliance to the
VAC position.
3. Open the lid. Place the open end of the bag down into the
vacuum channel, beneath the vacuum nozzle. The open
end of the bag must be clean and flat. Do not cover the
vacuum nozzle.
4. Close the lid. Press SEAL or VAC/SEAL button. The
indicator lights will become illuminated.
5. Using two hands, press on both sides of the lid. You will
hear a clicking sound if the electromagnet latch is correctly
locked.
6. When SEAL or VAC/SEAL indicator lights are off, the
appliance will automatically release the electromagnets.
Then open the lid to remove the bag.
IV. Tips for operating the scale
1. Remove the platform from the bottom of the appliance by
rotating anticlockwise. Then place it into the scale installing
port and rotate clockwise. Do not rotate the platform too
hard when installing. Otherwise, the weighing sensor may
become inaccurate because it is damaged.
2. Plug in the appliance (see point A of "Tips for vacuum
sealing a bag"). The digital scale can also by powered by
batteries when the appliance is not plugged in. Simply
place 2pcs AAA batteries into the battery compartment.
3. Gently turn both levers to the SCALE position. Only when
it is in the SCALE position can the platform be balanced.
If the platform is not balanced, the reading is impossible to