Replacing the diskette drive or optional card reader
This section provides instructions on how to replace the diskette drive or card
reader.
1. Open the computer cover. See "Opening the cover" on page 130.
2. Locate the drive or card reader cable connectors. See "System board connectors
3. Note the location of the drive or card reader cables. Disconnect the drive or
4. Press the drive latch 2 and slide the drive or card reader from the chassis.
5. Disconnect the flat cable from the rear of the failing diskette drive or card
6. Connect the flat cable to the new diskette drive or card reader.
7. Install the new drive into the drive-bay assembly and lock the drive or card
and components" on page 129.
card reader cables from the system board.
reader.
reader into position.
Chapter 10. Replacing FRUs (types 6427 and 6493)
151