Replacing The Diskette Drive Or Card Reader - Lenovo ThinkStation D20 Hardware Maintenance Manual

6. Remove the retainer bracket from the drive being replaced and install it on the new drive.
7. Slide the new optical drive into the bay from the front until it snaps into position.
8. Reconnect the signal and power cables to the new drive.
9. Go to "Completing the FRU replacement" on page 108.

Replacing the diskette drive or card reader

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkStation Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkStation
Safety and Warranty Guide, go to:
http://www.lenovo.com/support.
This section provides instructions on how to replace the diskette drive or card reader.
To remove or replace the diskette drive or card reader, do the following:
1. Remove the computer cover. See "Removing the cover" on page 78.
2. Remove the front bezel. See "Removing the front bezel" on page 82.
3. Locate the diskette drive or card reader. See "Locations" on page 79.
4. Disconnect the signal and power cables from the rear of the diskette drive. If you are replacing a
card reader, disconnect the card reader cable from the system board. See "Locating parts on the
system board " on page 81.
102
ThinkStation Hardware Maintenance Manual