Replacing The Front Panel Connector Assembly - Lenovo ThinkStation C20x 4269 Hardware Manual

Replacing the front panel connector assembly

This section provides instructions on how to replace the front panel connector
assembly.
10. Disconnect the front panel connector assembly cables from the system board.
11. Rotate the front panel connector assembly outward as shown and remove
12. Slide the front panel connector assembly cables out the opening in the front of
13. Route the front panel connector assembly cables and then position the new
14. Install the screw holding the front panel connector assembly.
15. Replace the hard disk drives. See "Replacing a hard disk drive" on page 112.
16. Replace the diskette drive or card reader if it was removed. See "Replacing
1. Open the computer cover. See "Opening the cover" on page 94.
2. Remove the front bezel. See "Removing the front bezel" on page 95.
3. Remove any installed adapters. See "Replacing an adapter card" on page 103.
4. To have easier access to the computer, lay it down on its side.
5. Remove the plastic adapter retainer in the front of the computer.
6. Remove the diskette drive or card reader if installed in this computer. See
"Replacing the diskette drive or optional card reader" on page 115
7. To have easier access to the front panel connector cables, remove the hard disk
drives. See "Replacing a hard disk drive" on page 112.
8. Remove the screw holding the front panel connector assembly.
9. Note the routing of the front panel connector assembly cables. They are routed
between the front frame and the hard disk drive bay.
See "System board connectors and components" on page 93.
from the computer. Be careful to not damage the cable connectors when
pulling the cables out between the front frame and the hard disk drive bay.
the computer.
front panel connector assembly
the diskette drive or optional card reader" on page 115
Chapter 9. Replacing FRUs (types 6423 and 6483)
121