Lubrication Points And Type Of Lubricant; Checking And Adjustment After Reassembly - Metabo C1810DFA Service Manual

Lubrication points and type of lubricant

Apply specified amount of grease to the following portions.
Grease (SEP-3A)
• Surface of the Base Ass'y [54] where Liner (A) [52] slides ·································· 5 g
• Surface of Shaft (B) [55] where the Turn Table [25] slides ··································· 0.5 g
• Surface of the Turn Table [25] where Liner (A) [52] slides ··································· 3 g
• Pinion of the Rotor Ass'y [100] and tooth surface
and gear chamber of the Spindle Ass'y [75] ··················································· 15 g
• Surface of Shaft (D) [10] ·············································································· 1 g
• Surface of the O-ring (P-6) [15] of the Stopper Pin Ass'y [14] ······························ 0.2 g
• Surface of the Hinge [13] where the Turn Table [25] slides ·································· 2 g
• Surface of the Gear Case [2] where the Hinge [13] slides (grease chambers) ········· 5 g x 2 places
• Inside of the Spring [5] ················································································ 5 g
• Surface of the Hinge [13] where Shaft (C) [12] slides ········································· 1 g
• Sliding surface of the Link [89] ······································································ 0.2 g
Please purchase the following grease as necessary.
Item
Grease (SEP-3A)
Advise the customer to lubricate the machine as indicated below at least once a month. Prior to lubrication,
any sawdust, dirt or other foreign matter should be thoroughly wiped away with a soft cloth.
(1) Swiveling section of the Gear Case [2] and Hinge [13]
Coat the swiveling and sliding portions of the Gear Case [2] and the Hinge [13] with machine oil.
(2) Vise ass'y section
Coat the screw thread portion of the Knob Bolt M10 x 66 [35] of the Vise Ass'y [33] with machine oil.
(3) Swiveling section of the Turn Table [25] and Hinge [13]
Coat the swiveling and sliding portions of the Turn Table [25] and Hinge [13] with machine oil.

Checking and adjustment after reassembly

1. Checking after reassembly
• Check that the motor section can be moved up and down smoothly by holding the handle portion of the
Switch Handle Set [106] with operating force 58.8 N {6.0 kgf} max.
• Check that the Turn Table [25] can be rotated to the left and right smoothly by holding the Side Handle
[26] with operating force 34.3 N {3.5 kgf} max. while the index stopper is released by pushing down the
Spring Plate [29].
• Check that the Lower Guard [90] moves smoothly and properly.
• Check that the Off Lock Lever [113] and Trigger [110] operate smoothly and properly.
• Check that the motor does not start by pulling the Trigger [110] without moving the Off Lock Lever [113] of
the Switch [114] (switch operating force:100 N {10 kgf}).
• Check that LED [84] turns on and off by pushing the LED button.
• Check for braking (blade stopping time: 5 seconds max.)
• Check that the rotating direction of the spindle is the same as the arrow mark on the Gear Case [2].
Registered part name
Grease (SEP-3A) (100 g)
Grease (SEP-3A) (2.5 kg)
-8-
Net weight Code No.
100 g 930035
2.5 kg 930038