Group And Reverb Channel Strips - MOTU 1248 User Manual

GROUP AND REVERB CHANNEL STRIPS

1
13
12
11
10
M O T U P R O A U D I O C O N T R O L W E B A P P
2
3
4
5
6
7
8
9
Group busses can be used to create a mix sub-group,
which is a set of inputs you wish to control together as a
group. Groups differ from aux busses in that they have
aux sends, a reverb send, as well as a main mix send. In
addition, group busses are equipped with the Leveler.
The Reverb bus is a special group bus that provides a
reverb processor. If you disable the reverb, the reverb bus
functions as a (fourth) regular group bus.
To access the Group and Reverb bus channel strips, go to
the Mixing tab (page 22), reveal the side bar (item #3 on
page 22), and then show the desired Group busses or
Reverb bus in the Mixer Outputs section (28).
To show and hide the four-band EQ section of the
channel strip, use the Controls section of the side bar
(item #3 in the Mixing tab on page 22).
1. A Group bus channel strip. Click the name to rename
it. Delete the current name to return to its default.
2. The Reverb bus. If you disable the Reverb processor, it
can be used as a fourth Group bus. The Reverb
channel strip is twice as wide as other mixer channel
strips to accommodate the Reverb processor controls.
3. Group busses and the Reverb bus are always stereo.
4. The four-band parametric EQ module for Group
busses and the Reverb bus operates the same as
described for input channels (items 10 and 11 on
page 24), including High and Low Shelf filter options.
5. The thumbnail EQ Graph displays the currently
enabled EQ filters, if any. Click it to open the full-size,
editable EQ Graph (Figure 8-3 on page 83).
6. The Leveler provides specialized gain reduction
modeled after the legendary Teletronix LA-2A Level-
ing Amplifier. For complete details, see "Leveler" on
page 85.
7. Sends to aux busses and, for groups, the reverb
processor.
8. The Reverb processor. For complete information, see
"Reverb" on page 86.
9. Main Mix sends.
10. Click to route the talkback mic to the group output.
11. Master faders for the Group and Reverb busses.
12. Mute and Solo.
13. Use these menus (hardware settings, output assign-
ment, and presets) in a similar fashion as described
for the Main Out bus (items 3-5 on page 25).
27