Lectric eBikes XP 3.0 Owner's Manual page 57

Tune-Ups
100 Mile Tune-Up
After 100 miles, or 5 full battery charge cycles, have the following
services performed at a bicycle shop:
• Brake cables may need to be adjusted and tensioned properly.
• Shifting cables will stretch during the wear-in period. The derailleur
may need to be adjusted.
• All hardware should be adjusted to the specified Tightening Torque
(p. 21). If any hardware is damaged, it may need to be replaced by
a bicycle mechanic.
Monthly (or about every 250-500 miles)
• Inflate tires to pressure within recommended range printed on
tire sidewalls.
• Lubricate chain.
• Check that all hardware is tightened to the torque specifications
listed in the Tightening Torque (p. 21) section of this manual.
• Check your brake pads for signs of wear. Replace if necessary.
• Check your bicycle's shifting performance. Adjust the derailleur
if necessary.
• Clean the bicycle with low residue cleaner and dry completely.
Lubricate after cleaning where necessary.
• Check spoke tension and adjust if necessary. See Tightening
Torque (p. 21).
Quarterly (or about every 750-1500 miles)
• Check all items on the monthly service list above.
• Check tire tread for excessive wear. Replace if necessary.
• Check electrical connectors and cable housings are secured away
from moving parts and are free from damage. Replace
if necessary.
Cleaning
Do not submerge your Lectric eBike or its components in
water, or use a pressure washer to clean.
Clean your Lectric eBike carefully with a soft, damp cloth (using only
mild soap and water). Rinse with water. The electrical components on
your Lectric eBike are IP 65 rated.
L E CT R I C E B I K E S.C O M | 602.715.0907 57