Lectric eBikes XP 3.0 Owner's Manual page 50

Key position shown: ON.
Turn the key clockwise so the key is
parallel with the frame. The key must
be turned to the ON position to turn
on the bike.
To uninstall:
To unlock the battery and remove it from the frame, follow the steps
listed above in reverse order. Be sure to remove the key from the
battery before removing the battery from the bicycle. If the key is
still in the battery, it will prevent the battery from being removed
from the frame.
When unlocking and removing your battery pack from the
frame, take care that it does not slide out while the bicycle is
folded. If your battery impacts the ground and is damaged,
discontinue use and contact Lectric eBikes immediately.
Storing
Charging Battery Pack Before and During Storage
When the battery pack will not be used for weeks or months, remove
it from the eBike and store the battery pack at about 60 % charge as
indicated by the Energy Bar on the display. At about 60% charge, the
battery will degrade less, compared to higher charge levels.
Every 2-3 months check the battery charge level and recharge to 60%,
if necessary.
Note: If the battery is stored with no charge for an extended period
of time, it may be damaged despite the low self-discharge and may
reduce the battery capacity.
For optimum service life for your battery pack, charge the battery
pack to 100% a few hours before you plan to ride. For example, if you
ride the bicycle and the charge level falls to 50% but you plan to use
the bicycle again in a few days, wait until the day before you plan to
use it again to charge it to 100%.
L E CT R I C E B I K E S.C O M | 602.715.0907 50