Table of Contents
Advertisement
Operating instructions
2
Safety
Read the following safety instructions carefully before
you operate the AS3500/3600 multi-point lock with
A-opener 2.1.
They are designed to keep you safe and prevent
hazards, injuries and material damage. Observe all
warning notes.
2.1
Electricity
Read the assembly instructions carefully before you
carry out any work on the AS3500/3600 multi-point
lock with A-OPENER 2.1.
• All work on a 230 V AC mains power supply may only
be performed by a qualified electrician.
• All work on the 230 V AC mains power supply
must be carried out in compliance with the current
German VDE regulations (e.g., VDE 0100) and any
relevant country-specific requirements.
• All-pole safety isolation should be used when fitting
the network connection cable on-site.
• Some external access control systems available on
the market transmit a brief "open" signal when the
operating voltage is switched on. This can mean that
the AS3500/3600 multi-point lock with A-opener 2.1
will open the door following a power failure. If in
doubt, please contact the system manufacturer.
If energy-carrying cables are routed in parallel to data
cables (ISDN, DSL, etc.), this could lead to interference
e.g. in the speed of the data transmission. We recom-
mend that you use the shielded KFV cable. See: Product
catalogue KFV GENIUS and A-opener.
H47.ELEKS005EN-00
Electromechanical systems
A-opener 2.1
02.2019
7/18
7/18
Advertisement
Table of Contents
