Panasonic S-36PU1E5A Technical Data & Service Manual page 82

1
How to connect wiring to the terminal
For stranded wiring
(1) Cut the wire end with cutting pliers,
then strip the insulation to expose
the stranded wiring about 10 mm and
tightly twist the wire ends. (Fig. 1-1)
(2) Using a Phillips head screwdriver,
remove the terminal screw(s) on the
terminal plate.
(3) Using a ring connector fastener or
pliers, securely clamp each stripped
wire end with a ring pressure terminal.
(4) Place the ring pressure terminal,
and replace and tighten the removed
terminal screw using a screwdriver.
(Fig. 1-2)
Examples of shield wires
(1) Remove cable coat not to scratch braided shield. (Fig. 1-3)
(2) Unbraid the braided shield carefully and twist the
unbraided shield wires tightly together. Insulate the shield
wires by covering them with an insulation tube or wrapping
insulation tape around them. (Fig. 1-4)
(3) Remove coat of signal wire. (Fig. 1-5)
(4) Attach ring pressure terminals to the signal wires and the
shield wires insulated in Step (2). (Fig. 1-6)
Wiring samples
U1 type
Clamper*
1
Clamper*
Power
Clamper*
Supply
Clamping Clip
Protective ground screw
(External Solenoid Valve
Kit for 3WAY)
Functional ground screw (External Electronic
Expansion Valve Kit and Schedule Timer)
*1 Fasten tightly.
Stranded wire
1
Remote Control
Wiring
Inter-unit Control
Wiring
1
Use this screw when connecting
the shield for the Inter-unit control
wiring to ground.
Special
washer
Ring
pressure
terminal
Wire
Fig. 1-1
F1 type
Use this screw when connecting the shield
for the Inter-unit control wiring to ground.
Protective ground screw
1-250
Screw
Ring pressure
terminal
Terminal plate
Wire
Fig. 1-2
Fig. 1-3
Insulation tape Shield mesh
Fig. 1-4
Insulation tape Shield mesh
Fig. 1-5
Fig. 1-6
Functional ground screw
Power Supply
Screw and
Special washer
Ring
pressure
terminal
Remote
Control
Wiring
Inter-unit
Control
Wiring