Troubleshooting - La Crosse Technology WS-9043U Instruction Manual

Wireless 433 mhz radio-controlled weather station
Table of Contents

Advertisement

The remote temperature/humidity sensor can be mounted in several ways:
• With the use of screws
• Using adhesive tape
MOUNTING WITH SCREWS
A.
1) Remove the mounting bracket from the
2) Place the mounting bracket over the
3) Through the two screw holes of the
4) Screw mounting bracket onto the mounting surface. Ensure that the screws are tight
5) Insert the remote temperature/humidity sensor into the bracket.
B.
1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the
2) Remove the protective strip from one side of the tape.
3) Adhere the tape to the designated area on the back of the mounting bracket.
4) Remove the protective strip from the other side of the tape.
5) Position the remote temperature/humidity sensor in the desired location, ensuring that
II. THE INDOOR WEATHER STATION
The indoor weather station can be mounted in several ways:
• With the use of screws
• Using its foldout stand
A. MOUNTING WITH SCREWS
1)
2)
3)
B. FOLDOUT TABLE STAND:
The foldout table stand leg is located on the backside.
1) Pull the stand out from the bottom center edge of the weather station, below the
2) Once the foldout table stand is extended, place the weather station in an appropriate

TROUBLESHOOTING

NOTE: For problems not solved, please contact La Crosse Technology.
Problem: No reception of WWVB time signal.
Solution: 1) Wait overnight for signal.
remote temperature/humidity sensor.
desired location.
bracket, mark the mounting surface with a pencil.
against the bracket.
MOUNTING WITH ADHESIVE TAPE
mounting surface to ensure a secure hold. The mounting surface should be smooth
and flat.
the indoor weather station can receive the signal.
Fix a screw (not included) into the desired wall, leaving
approximately 3/16 of an inch (5mm) extended from the
wall.
Place the indoor weather station onto the screw using the
hanging hole on the backside.
Gently pull the indoor weather station down to lock the
screw into place.
battery compartment.
location.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents