Setting Parameters For Odi And Ndis Drivers; Odi - Net.cfg - Proxim RangeLAN2 752 Series Manual

RL2ISA.COM is a DOS ODI driver. RL2ISA.DOS is a DOS
real-mode NDIS 2 driver.
If the installation procedure does not have an "OEM-supplied"
option, choose a network interface card from the given list. This
card's ODI or NDIS driver will then be installed. After installa-
tion, you will need to manually search for all instances of this
driver and replace them with either RL2ISA.COM if an ODI
driver was installed or RL2ISA.DOS if an NDIS driver was
installed. Additionally, you will need to replace the installed
driver's configuration with the RangeLAN2 options in the ASCII-
editable NET.CFG or PROTOCOL.INI file for the ODI or NDIS
driver respectively.

Setting Parameters for ODI and NDIS Drivers

A sample NET.CFG and PROTOCOL.INI file are listed:

ODI - NET.CFG

LINK DRIVER RL2ISA
int
port
domain
station_type
frame ethernet_802.3
Sets Interrupt (IRQ) line to be used. Valid
15
options are 3, 4, 5, 7, 10, 11, 12, or 15.
Sets the I/O Port Address. This Port must
270
match the dip switch setting.
Sets the network Domain. This must match
0
the Domain of the server or Access Point to
which you want to connect and be a number
between 0 and 15.
Sets the status of the RangeLAN2 7100 card
0
as Master (2), Alternate Master (1), or non-
master (0) Station.
Indicates that RangeLAN2 sends Ethernet
packets that follow the 802.3 specification.
33