Dos Installation; Installing Drivers Using Rl2Setup - Proxim RangeLAN2 752 Series Manual

This chapter describes the installation of the DOS driver software
and utilities once the hardware has been installed, as described in
Chapter 2.

Installing Drivers Using RL2SETUP

If your Network Operating System (NOS) does not have an
installation procedure, you may use RL2SETUP to install the
ODI or NDIS driver software.
Put the RangeLAN2 7100 DOS driver diskette in a floppy drive
on your computer and run the setup program:
C:\> A:
A:\> RL2SETUP
If you wish to install the ODI driver, choose ODI Peer-to-Peer or
ODI with Access Point (depending on whether or not the station
will communicate through a RangeLAN2 Access Point) as the
NOS and then click the <Install Files> button. If you wish to
install the NDIS driver, choose Generic NDIS Peer-to-Peer or
NDIS with Access Point (depending on whether or not the station
will communicate through a RangeLAN2 Access Point) as the
NOS and then click the <Install Files> button. Set the directory
name to match that of the NOS directory. The proper driver and
configuration file will be installed. Next, choose <Configure>
and set the proper software options.

4. DOS Installation

(or B:)
31