Table of Contents
Advertisement
Installation of the Card
After setting the I/O Port Address, you are ready to install the
card. The card may be placed in either a 16-bit ISA-bus slot or an
8-bit ISA-bus slot in your computer.
1.
Turn off your computer and unplug it from the wall outlet
for safety.
2.
Remove the computer cover.
3.
Locate an unused ISA slot and use a screwdriver to remove
the retaining screw. Remove the metal slot cover.
4.
Align the RangeLAN2 card over the slot and insert it firmly
into the slot.
5.
Use the screw from the slot cover to secure the card's metal
bracket to the computer.
6.
Replace the computer cover.
7.
Plug the computer back into the wall outlet.
Antenna Installation
1.
Locate the antenna connector of the RangeLAN2 7100 at
the back of your computer as shown in Figure 5 below.
2.
Firmly screw the end of the RangeLAN2 antenna cable
onto the connector in a clockwise motion. Place the antenna
on top of your desk or computer.
7
Advertisement
Table of Contents
