Table of Contents
Advertisement
Vehicle Electrical Installation Kit
The kit contains a circuit breaker to protect from excessive current being drawn
from the vehicle's electrical system, and also provide a safe and easy way to
switch the voltage from the vehicle's battery "off" to facilitate the removal of the
sprayer. Also included are 3 different sets of battery adapters to fit most
batteries, and a sufficient quantity of red and black 6-gauge cable and ring
terminals to create a power harness custom fit to your vehicle.
It is important to pay close attention to the methods and paths chosen to route
the cable to the sprayer. Be sure to avoid rotating parts, sharp edges, or
anything that may abrade, cut, or cause damage to the insulating protective
coating on the cable. The use of rubber or plastic tubing, hose, grommets, and
other protective materials is highly suggested.
The circuit breaker should be located as close to the vehicle's battery as is
practical. It should be mounted to a flat solid surface such as the fender-well.
Since the circuit breaker is on the positive (+) side of the battery, avoid contact of
the exposed ring terminals with any metal parts of the vehicle that may provide a
path to ground (-) and cause a short circuit! Pushing the red button on top of the
unit will trip the breaker and open the circuit so that voltage will not pass beyond
the breaker. Pivoting the reset bar inward will activate the breaker and allow the
voltage to pass through the cable to the atomizer battery. (See Figure #1) Be
sure both the vehicle and the atomizer batteries are fully charged before
activating the circuit breaker!
P/N-65287
Figure 1
46
Advertisement
Table of Contents
