Table of Contents
Advertisement
Connecting the Dyna-Jet L30 to the Vehicle Electrical System
Refer to the Vehicle Installation Kit Instruction Sheet for detailed
Securely mount the 60 amp circuit breaker using the (2) Hex Bolts, Washers and Lock
Nuts provided.
To avoid damage to the machine and vehicle, ensure that the battery on the SPRAYER
has been fully charged before attaching to vehicle battery.
The circuit breaker carries high current. Do not allow any conductive material (metal,
etc ) to contact the bare wires or connection terminals. Doing so can cause a short
circuit and produce sparks that could lead to a fire or explosion resulting in serious
injury or death! Ensure that rubber terminal caps are securely in place after connecting
cables! Do not mount the circuit breaker outside of the vehicle. The breaker should be
mounted in the engine compartment using the hardware provided, in a suitable location
near the vehicle battery. The fender-well is usually ideal, and has the advantage of
being an insulator (if it is plastic) to reduce the likelihood of shorting the ring terminals
on the breaker which will have positive electrical potential.
PART NO.
120214
120382
120392
121900
65167
65168
65169
65171
65176-2
65176-3
65176-4
65305
65306
9419454
RM65188
RM65189
installation instructions.
IMPORTANT
WARNING
QTY
DESCRIPTION
2
Washer, lock, 5/16 split
4
Washer, lock, 3/8 split
4
Washer, flat, ¼, reg.
2
Bolt, ¼-20 x 1, hex
2
Adaptor, battery post (GM reg)
2
Adaptor, battery post (GM)
2
Adaptor, battery post (Ford)
1
Breaker, hi-amp
3
Terminal, ring, 6g, ¼
4
Terminal, ring, 6g, 3/8
4
Terminal, ring, 6g, 5/16
4
Nut, jam, brass 3/8-16
2
Nut, jam, brass 5/16-16
2
Nut, nylock ¼-20
Cable, 6g, black (300 inches)
Cable, 6g, red (300 inches)
23
Advertisement
Table of Contents
