Connecting Your Monitor - Iiyama ProLite T2452MTS-B5 User Manual

CONNECTING YOUR MONITOR

Ensure that both the computer and the monitor are switched off .
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
Connect the monitor to the audio equipment with the Audio Cable for computer when using the
audio features.
Connect the Power Cable to the monitor fi rst and then to the power supply.
Turn on your monitor and computer.
NOTE  The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama offi ce.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama offi ce for a suitable adaptor.
 Make sure you tighten the fi nger screws at each end of the signal cable.
 Excessive sound pressure from ear-/headphones can cause hearing damage/hearing
loss.
[Example of Connection]
Power Cable (Accessory)
[ Collect Cables ]
Remove the Cable Cover and pass the cables.
Put the cables through the cable hole of the back.
Place the Cable Cover.
Front
<Back>
Cable Cover
HDMI Cable
(Not included)
VGA(D-sub) Signal Cable
(Accessory)
DVI-D Signal Cable (Accessory)
Audio Cable (Accessory)
USB Cable (Accessory)
BEFORE YOU OPERATE THE MONITOR 9
AV Equipment etc.
Computer
Cable Hole