Toyota Sienna Owner's Manual page 31

The beep will sound once,
1
and the AUTO ACCESS
SEAT will begin to move
automatically while the seat-
back reclines.
The indicator light on the wire-
less remote control will flash.
The AUTO ACCESS SEAT
2
will rotate while the seatback
raises and while moving
towards the rear of the vehi-
cle.
Once the seat has rotated fully,
the beep will sound once and
the seat will stop moving auto-
matically. Release the switch at
this time.
Return the wireless remote control to the AUTO ACCESS SEAT.
7
(P. 26)
Adjust the AUTO ACCESS SEAT as necessary (P. 8), and buckle
8
the seat belt before driving.
Close the right-hand sliding door.
9
■
Wireless remote control
●
When the seat raise switch is pressed, the beep will sound once and the
AUTO ACCESS SEAT will begin to operate. The seat will not operate if the
switch is pressed repeatedly.
●
The AUTO ACCESS SEAT will stop operating if the seat raise switch is
released during operation.
SIENNA_AAS_OM08011U_(U)
1-2. Operating the AUTO ACCESS SEAT
31
1