Table of Contents
Advertisement
56
3. When you think a malfunction has occurred
Turn the bolt with yellow mark-
12
ing clockwise using the combi-
nation wrench, and slide the
seat until the marks are aligned
as shown in the illustration.
If you are unable to slide the seat
until
the
because the right edge of the seat
cushion interferes with the sliding
door, carry out steps
slide the seat until the marks are
aligned as shown in the illustration.
Use the combination wrench to
13
loosen the two bolts, then slide
the motor out of the way and
disconnect it from the gear.
Rotate the seat into a position
14
which does not cause the left
edge of the seat cushion to
make contact with the vehicle
body.
SIENNA_AAS_OM08011U_(U)
marks
are
aligned
and
and
13
14
Advertisement
Table of Contents
