Toyota Sienna Owner's Manual page 32

32
1-2. Operating the AUTO ACCESS SEAT
■
Jam protection function
If the operation of the AUTO ACCESS SEAT is interrupted by collision with an
obstacle etc., the beep will sound twice and the seat will retreat slightly and
then stop. If this happens, make sure that the hands, feet etc. of the occupant
will not hit the body of the vehicle, and operate the seat once again after
removing the obstacle.
■
Conditions which will halt operation
If another wireless remote control or the seat raise/lower switch are operated
while the AUTO ACCESS SEAT is being operated by wireless remote control,
the AUTO ACCESS SEAT will stop operating.
■
If the AUTO ACCESS SEAT has not been stowed properly
The following operations cannot be carried out.
●
Power sliding door function (right-hand sliding door only)
●
Shifting
●
Adjustment of the seat position and seatback angle of the AUTO ACCESS
SEAT
WARNING
■
Before returning the AUTO ACCESS SEAT to the vehicle
● Check that the right-hand third seat occupant is safe.
Their feet etc. may get caught between the AUTO ACCESS SEAT and the
vehicle body, possibly causing an injury.
●
Make sure that the right-hand sliding door is fully open. Otherwise, the
hands or feet of the occupant may hit the door when the AUTO ACCESS
SEAT is operated, possibly causing an injury.
SIENNA_AAS_OM08011U_(U)