Table of Contents
Advertisement
Cleaning the extractor hood
Clean the extractor hood and the aluminium-
design ventilation ducts (LK 590-011/021/031)
with a soft cloth and mild detergent solution only.
Clean the stainless-steel design ventilation
ducts (LK 590-010/020/030) with mild detergent
solution and apply stainless steel care agent to the
metal surface using a soft cloth.
Cleaning the glass plates
Apply commercially available window cleaning
agent with a soft, moist cloth.
To facilitate cleaning, you can detach the glass
plates as follows:
Detach the grease filters. In the extractor hood, you
will find two openings on the upper side through
which you can lift the glass plates singly with a
blunt object (e.g. handle of a wooden spoon) to
Fig. 15
detach them with greater ease. The remaining
glass plates can then be lifted from above.
If they are extremely soiled, the glass plates can be
cleaned in a dishwasher at a maximum temperature
of 55 °C.
Note: when putting the glass plates back in place,
make sure that you do not scratch the chimney.
Replace the glass plates with the printed side
facing down. Position the glass plates at the chim-
ney side first.
Cleaning the aluminium panel
Clean the control panel with a sponge and mild de-
tergent solution only. Dry with a soft, dry cloth. Do
not use any strong or caustic cleaning agents or
brushes and abrasive cleaner to clean it. Do not use
strongly alkaline cleaning agents (such as oven
spray) because these are aggressive to the
aluminium surface. Do not use any abrasive
sponges either.
10
Advertisement
Table of Contents
