Table of Contents
Advertisement
INSTALLATION OVERVIEW
The ice machine must:
• Be connected to cold, potable water.
• Be connected to a drain.
• Be connected to the proper power supply.
• Be able circulate air through the vents at the front.
Note: DO NOT build in so that the door is recessed. Door is meant to be flush with surronding cabinetry, but
not recessed.
INSTALLATION PARTS
The following installation parts are supplied with the ice machine:
2-Hinge covers
2-Hinge side covers
2-Hole plugs
2-Hinge opening covers
ACCESSORY DOOR PANEL
The ice machine is supplied without a finished door panel. Accessory door panels are offered or a custom panel may be
used.
Accessory Door Panel Attachment
Note: If door swing is to be changed, it must be done before panel is attached.
To attach a door panel:
The panel will be held on by 6 screws (supplied with door panel) and 2 machine screws (supplied with ice machine).
1. Remove the gasket and retain for later use.
2. If the door panel is stainless steel, remove any plastic covering the
stainless steel panel.
3. Place the panel onto the outside of the door, and secure it to the door
using two machine screws, located at the left center and right center ( -
behind door gasket).
4. Fasten the panel to the door using the 6 screws (supplied with door
panel). In the hinge area, use the outermost screw holes.
5. Place the covers over the hinge areas, and secure each cover to the
door using a screw (supplied with door panel).
6. Insert hole plug over screw installed in step 5 (supplied).
7. Return the gasket to its original position.
CUSTOM PANEL
A custom panel of wood or other material not exceeding 15 lb can be
attached to the door. Attachment is from the ice side of the door. Holes
are provided in the door for this purpose.
To create and attach a custom panel:
•
Panel width: 14-7/8" (37.9 cm)
•
Panel height: 30-5/16" (77.0 cm)
•
Panel thickness: 5/8" (14.5 cm) to 3/4" (1.9 cm)
1. Measure overall height of cabinet opening where ice machine will be (floor to botom of countertop edge).
2. Determine desired kickplate space (from bottom of door to floor). This could be equal to the adjacent cabinet's
kickplate space or another space the user wants.
3. Subtract kickplate space from cabinet opening.
4. Subtract 1/8" or more for clearance space between top of door and bottom of countertop edge from cabinet opening.
This is the maximum door length.
5. Cut panel to width
2-Door stop pins
10-#8 sheet metal screws
2-8-32 Machine screws
4-Leveling leg caps
1-Upper door bracket (LH)
1-Lower door bracket (LH)
2-Black kickplate screws
1-Access panel button cover
10
Hole
plug
Cover
Gasket
Advertisement
Table of Contents
