Table of Contents
Advertisement
Hook Up An Over-The-Air Antenna
Connect an off-air antenna.
Locate the Antenna/Cable jack on
1
the back of the TV.
Connect the antenna that runs from
2
the wall directly to this jack,
according to one of the connection
diagrams shown to the right.
Remove the back of the remote
3
and put in two AA batteries.
Plug in your TV. This TV is
4
designed to operate on standard
current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC
Current.
If you have a 75 ohm RF cable, then you
don't need any adapters!
A 300 to 75 ohm adapter is not included
with the LG TV.
Mini Glossary
The wire that comes from an off-air antenna or cable service provider. Each end looks
75 OHM RF
CABLE
like a hex shaped nut with a wire sticking through the middle, and it screws onto the
threaded jack on the back of the TV.
300 TO 75
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They
are usually about an inch long with two screws on one end and a round opening with a
OHM
wire sticking out on the other end.
ADAPTER
Page 10
Back of the
Remote
120 Volt
60 Hz AC
An tenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr
Pb
R Audio L
Cable
Y
Video In
R Audio In L
M.P.I.
Typical
TV Back
Matrix Out
Component Video Input
Antenna
Pr
Pb
R Audio L
Cable
Y
Video In
R Audio In L
M.P.I.
Advertisement
Table of Contents
