Installation - HABYS evero V4 Manual

I. APPLICATION
The stationary massage tables HABYS Evero enable the physiotherapists to perfom correct, safe
and effective rehabilitation treatments, physiotherapy, physical therapy and massage aiming at
treating or alleviating the course of illnesses and the results of injuries/impairments. The frame of
the rehabilitation tables Evero enables an easy and complete access to the patient from each side.
II. INSTALLATION
1. Unfolding
Unfold the table.
•
Check whether it has not been damaged during transportation. Should the table be damaged,
•
do not install the table and inform the seller immediately.
2. Connection to the power supply
Before inserting the plug into the power socket, make sure that:
the socket is properly grounded and complies with the binding regulations;
•
the socket may sustain a load of the maximum power output of the device, given in the chart
•
of the Technical Data;
the voltage of the electrical power is in accordance with the data given in the chart of the
•
Technical Data;
the plug fits into the socket. Otherwise the socket needs to be replaced.
•
!
Do not install the devices in the open air.
ź
Electric actuators may work no longer than 2 minutes.
ź
Restart is possible after 18 minutes of rest.
ź
After installation of the table the power socket should be easily accessible.
ź
Do not use the extension cords.
ź
The cable should not be bent.
ź
The cable of the power supply may be replaced only by an authorised
ź
specialist.
Independent repairs of the electric actuators cannot be performed.
ź
Avoid direct sunlight, UV radiations, rain, extensive dust, moisture.
ź
Attention!
The manufacturer declines all responsibility if the user doesn't follow the above
mentioned rules.
EN
9